30-06guy's Recent Activity

  1. 30-06guy replied to the thread Frozen bolt in exhaust manifold.

    "I ended up replacing the cast iron factory stuff with cast aluminum GLM manifolds and risers, for about the same $$ and 80# less weight...

    May 21, 2018 at 7:29 PM
  2. 30-06guy replied to the thread Frozen bolt in exhaust manifold.

    His tip about getting a couple of longer bolts and cutting the head off to use as a guide is spot on. When I did mine, I did just like...

    May 21, 2018 at 7:20 PM
  3. 30-06guy liked duckhunter's post in the thread Frozen bolt in exhaust manifold.

    This right here ^^^^ I did a number of exhaust manifold bolts on our old Donzi. I used a combination of drill and cold chisel to get...

    May 21, 2018 at 7:03 PM
  4. 30-06guy liked Tunatown's post in the thread Frozen bolt in exhaust manifold.

    If you do end up grinding the head of little heat the oil I will help suck it into the treads a good tool besides the vise grips is a...

    May 20, 2018 at 9:06 PM
  5. 30-06guy replied to the thread Frozen bolt in exhaust manifold.

    When I did mine, I used a small pneumatic cut off tool. It's not a lot bigger than your hand and takes a little 4 inch cut off blade. I...

    May 20, 2018 at 8:19 PM
  6. 30-06guy liked El Mar's post in the thread Frozen bolt in exhaust manifold.

    Try this thing..... [MEDIA]

    May 20, 2018 at 7:32 PM
  7. 30-06guy replied to the thread Frozen bolt in exhaust manifold.

    I had the same issue once. I ended up grinding the head of the bolt off and getting the exhaust manifold out of the way. Once that...

    May 20, 2018 at 6:47 PM
  8. 30-06guy replied to the thread Bow Swivel Rod Holder.

    Not yet. Life kind of got busy the last couple of weeks. I'm hoping next week or so to get on it. I will start a new thread when I do. I...

    May 17, 2018 at 6:14 PM
  9. 30-06guy replied to the thread Bow Swivel Rod Holder.

    I know they sell them at New England Marine and Industrial in Portsmouth NH. I don't know what they get for them though.

    May 16, 2018 at 2:36 PM