47' "Rattle Snake" Osmond Beal by H&H Marine Inc

[admin]

Builder: H&H Marine Inc. Steuben ME
Owner: Derek Feeney, Cutler, ME
Dimensions: 47'4" x 19'2" x 5'4"
Designer: Osmond Beal, Beals ME
Fishery: Lobster
Hull: Solid fiberglass
Top: Molded unit/Divinycell foam cored
Power: DI16 Scania (800 hp @ 2200 rpm) w/2.4:1 ZF gear; Toppin's Diesel & Marine
Speed: 22.5 knots (GPS)
Prop: 38" x 36" x 4; H & H Propeller Shop Inc.
Shaft: 3"; H&H Propeller Shop Inc.
Bearings: R.E. Thomas Marine Hardware Inc.
Steering: Marine Hydraulic Engineering Co. Inc.
Hauler: Marine Hydraulic Engineering Co. Inc.
Metal fabrication: Esposito's Welding
Electronics: Win-Tron Electronics
Fuel Capacity: 500 gallons (two tanks)

Comments: Here it is, at long last: the first of the Osmond 47s, H&H Marine's latest and largest offering to date. This behemoth is rated at 43,000 pounds displacement. After sea trials, one more inch of pitch was prescribed for the wheel.[attachment=0:3qnnk83g]14rattlesnake.jpg[/attachment:3qnnk83g]

 

[Tumblehome]

All the boats are bigger in Cutler.

 

[Tumblehome]

From left to right: 45 Young Bros., 42 Wesmac, 42 Osmond (H&H), 40 Wayne Beal, and finally, a 38 Holland. As seen at the Jonesport/Beals boat races, 7/11.

 

[thebridge]

I have a 29'6 H&H Osmond Beal and love it!! Has a 220 JD and is great in a forward sea. Use if for lobster

 

[Aspiration33]

That is a 46' Young Brothers. Its owned by Nick Lemuigh in Cutler, the "Phantom".

 

[Bill]

Old thread bump..

 

[Badlatitude]

What a beast!

 

[Dslpwr]

Another 47 Osmond F/V Monica Tyman

 

[twister]

That's one hell of a picture

 

[MDI45]

Another 47 Osmond F/V Monica Tyman

What a beast...what u have for power ?

 

[Dslpwr]

It's my customer 800hp Scania DI16 same setup as the Rattlesnake. Fishes out of Milbridge ME

 

[MDI45]

It's my customer 800hp Scania DI16 same setup as the Rattlesnake. Fishes out of Milbridge ME

Nice....I could use a Scania 800 for my 45 MDI..lol

 

[BOSBoatMan]

Set the water on fire, jesus!